Sidebar
gcode:order_of_execution
Table of Contents
Order of execution
Modal state
- Units: G20, G21, G70, G71
- Plane: G17, G18, G19
- Distance Mode: G90, G90.1, G90.2, G91, G91.1, G91.2, M82, M83
- Lathe Mode: G07, G08
- Cycle Return: G98, G99
- Polar Mode: G15, G16
- Feed Mode & Speed: G93, G94, G95, F
- Spindle Mode & Speed: G96, G97, S
Settings
- Settings: G10
- Set Home: G28.1, G30.1
Tools
- ToolSelect: T
- ToolChange: M6, M61
Inputs & Outputs
- Spindle & Coolant: M3, M4, M5, M7, M17, M8, M18, M9
- IO: M10, M11, M59, M62, M63, M64, M65, M66
Control
- Overrides: M48, M49, M50, M51, M53, M54, M55, M56, M57
- Pause: M0, M1
- Sync & SetPosition: G09
- Blend Mode: G61, G61.1, G64
Offsets
- Tool: G43, G43.1, G44, G44.1, G49, G40, G41, G41.1, G42, G42.1
- Work: G92, G92.1
- Axis: G52, G52.1, G50, G51, G68, G69
- CoordinateSystem: G54, G54.1, G55, G56, G57, G58, G59, G59.1, G59.2, G59.3
Comments
- clear, print, status, msg, clipboard, mdi,
- log, logcreate, logopen, logclose,
- paramsclear, txt,
- pointsclear, pointssave, pointsload, pointsshapes, point, pointpos,
- py, pythr,
- name, desc, dlgname, dlg, dlgshow,
- arrclr, array, arrchr, crc16, crc32,
- sw_reset, sw_print,
- block_begin, block_end,
- usb, expr,
- color
Motion
- Cancel Motion: G80
- Linear Feed Move: G00, G01
- Arc Move: G02, G03
- Curves: G05, G05.1, G05.2, G05.3
- Home: G28, G30
- Probe: G31, G38.1, G38.2, G38.3, G38.4, G38.5
- Sync: G32, G33, G33.1
- Shapes: G06, G06.1, G06.2, G06.3
- Cycles: G75, G76, G77, G78, G79, G12, G13, G72, G72.1, G72.2, G81, G82, G83, G84, G85, G86, G87, G88, G89, G73, G74
Delay
- Dwell: G04
gcode/order_of_execution.txt · Last modified: 2023/03/22 12:20 by 127.0.0.1