Home
PlanetCNC TNG
Introduction Overview Installation
User Interface
Main Window
File Menu
View Menu
Program Menu
Machine Menu
Emergency Stop Start Stop Pause Start Options Overrides Speed Override Spindle Override Pause Enable Pause Optional Single Step Mist Flood Spindle Output ExtOut Motor, Limits, Probe Motors Enable Soft Limits Enable Hard Limits Enable Probe Trigger Tools Current Change Select Edit Tool Table Edit Tool Slots Measure Current Tool Measure All Tools Move To Zero To... Axis To Zero To G28, G30 To Selected Line To Mark Program Bounds Position To Camera Camera To Position Camera To Sel. Line XY Machine Position To Zero To... Axis To Zero Unwind Measure Height As G28, G30 Reset THC Work Position To Zero To... Axis To Zero From Program Measure Height Offset To Zero Offset To... Offset Axis To Zero Selected Line Camera Coordinate System Current Select To Zero To... Axis To Zero Measure Height Offset To Zero Offset To... Offset Axis To Zero Edit Coordinate Systems Tool Offset Enabled To Zero To... Axis To Zero Measure Length From Tool Table Home Cycle Mill Facing Mill Profile Mill Pocket Mill Circular Pocket Drill Drill Tap Turn Facing Turn Roughing Turn Repeating Turn Finishing Turn Grooving Turn Threading Measure Probe Calibration Edge Find Edge Position Edge Angle Inside Corner Outside Corner Hole Protrusion Slot Tab Surface Height Surface Angle Surface Gantry Square Points Count Load Save Save STL Save DXF To Output Clear Add From Position Add From Camera Camera Show Mark Read Calibrate Scale Set Offset User Commands Controller Reconnect Reset Firmware Update Advanced
Help Menu
Settings
Parameters
User can save, load or export measured point collection.
See also pointpos and point G-code comment functions.
Displays current count of measured points.
Loads previously saved file of measured points.
Save measured points to file.
File format is compatible with Import CSV.
Save measured points to STL file.
Points must represent surface otherwise STL file will be gibberish.
Save measured points to DXF file.
Points must represent shape otherwise DXF file will be gibberish.
Measured points are printed to the output window.
Clears all currently measured points.
Stores current position as new point.
Stores camera position as new point.
