Program Options - Probe & Measure

Assigns digital input pin of controller as Probe 1. Input pin is selected from drop down menu.

Assigns digital input pin of controller as Probe 2. Input pin is selected from drop down menu.

Related parameters

Probe speed is speed at which machine measures different geometries under Machine/Measure menu.

After initial first probe activation, machine will repeat measurement again, but this time at Low speed.

Related parameters

Length of probe.

Related parameters

Radius of the stylus ball of touching probe.

In a case where probe center is not aligned with Z axis center over X axis, user can set offset value.

In a case where probe center is not aligned with Z axis center over X axis, user can set offset value.

Related parameters

Related parameters

Related parameters

This is the distance from the tip of the probe stylus ball to the edge of the probe shoulder. This value is considered when calculating distances in the measurement procedure so that the probe is not damaged.

Related parameters

TNG offers option where tool in tool table can be set as probe. When this option is enabled, probe properties(diameter, speed, length) are considered the one that are set in the tool table.

Related parameters

Height value to which machine ascends in-between the measurement procedure.

Related parameters

Height distance for which machine retracts after probe activation.

Related parameters

During machine operation(machine jogging or NC program execution), if probe input is activated, Estop will be activated.

Related parameters